This option will allow us to define the section of a trench with the associated pipe, so that in the following commands we can both draw and locate it.
When executing the command, the program will initially ask us for the file where the data related to the position of the pipe and the different materials to be filled will be stored (extension . TUB).
Point of application of the grade
We can indicate the point where the level of grade is applied, we have three possibilities:
1.Water Sheet: The level of grade goes at the point of support of the pipe on the ground.
2.Center of the Tube: The level of grade is applied on the geometric center of the tube.
3.Trench bottom: The grade level is applied at the base of the trench.
4.Listados
The configuration of the pipe by pks and the different materials between each interval will be introduced.
Up toP.K.: Pk to which we define the pipe section.
Diameter: Diameter of the pipe.
Thickness (mm): Thickness of the pipe. This parameter affects the measurements.
Bed Material: Name of the pipe bed material. It will be reflected in the listings of Surfaces and Volumes.
Bed Height: Vertical distance between the bottom of the trench and the support point of the pipe (water sheet).
Thickness
Earth Layers:
We define the different strata of land with which we are going to fill the trench, you can introduce up to a maximum of 4 types of land, specifying the name and thickness of it. Land thicknesses are counted from bed height.
TcpMDT
