These commands allow one to change the tangent points
(entry and exit) of the transition curve defined at the current vertex. There
are three different options.
“A”:
If a transition curve has been defined at the previous vertex, MDT will change
the tangents of the previous and current vertices so that the exit and entry
tangents of both vertices coincide.
“P”:
If a transition curve has been defined at the next vertex, MDT will change the
tangents of the next and current vertices so that the exit and entry tangents
of both vertices coincide.
“<”: When this button is clicked, MDT will graphically request the
distance to the tangent to be set from the current vertex. In this case, the
entry and exit tangents will be equalled.
<: Establishes as the current vertex
previous vertex to the one currently being edited.
>: Establishes as the current vertex
the following vertex to the one currently being edited.
Apply
: Updates all the changes made on the drawing.
Once the dialogue box
has been validated, all the changes made at each of the vertices will be
applied to the drawing.
Related Topics